Gxt V095-01 Automotive Analyzer Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Ausrüstung Gxt V095-01 Automotive Analyzer herunter. GxT V095-01 Automotive Analyzer User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken

Inhaltsverzeichnis

Seite 1 - Automotive Analyzer

1Operator’s ManualAutomotive AnalyzerIt’s More than a Multimeter

Seite 2 - Table of Contents

10Lo AmpsWhen the test is first selected the message “PLUG In LO” will be briefly displayed to remind the user that the Low range Amps p

Seite 3 - Extreme Static Discharge

11Volts • AmpsPressing the button will cycle you through the Volts•Amps Display and a Battery/Starter Test. The High range amp probe is used

Seite 4

12TimePress the Time button to cycle through Hertz, Pulse Width (Up Slope), Pulse Width (Down Slope), Dwell milliseconds, and Dwell percent tes

Seite 5 - Function Buttons

13Fuel TestThe Black amps probe will need to be connected to the wire that supplies battery power to the fuel pump. Energize the pump

Seite 6

14Coil TestPress this button to cycle through two Current Ramping tests (Peak Amps, Build Time, Drive Time), Ignition KV, and Differentia

Seite 7 - AC Voltage Display

15Coil Test - KV Test (Requires Optional Adapter)1. Unplug the Spark Pickup from the multimeter. 2. Connect the KV adapter to the multimeter. 3.

Seite 8 - Diode Display

16Coil Test - Fuel Injector ApplicationPeak Amps is the peak current driving the injector. It is regulated by the driver. Typical peak readings ar

Seite 9 - AC Amps Display

17Coil Test - Ignition Coil ApplicationPeak Amps is the peak current driving the coil. It is regulated by the module. A typical Peak Amp reading sh

Seite 10 - AC LoAmps Display

18Parts & AccessoriesTest Lead, P/N W090-926 foot Shielded Test lead. BNC connector at one end, and banana jacks at the other end.Lo Amps Probe,

Seite 11 - Volts • Amps

19Parts & AccessoriesSerial Lead, P/N V095-PCPlugs into the Amps jack on the meter and provides a Y adapter so you can connect your amps pro

Seite 12 - Dwell Percent Display

2Table of ContentsSpecifications ...3Static Discharge Notice ...

Seite 13 - Fuel Test

20WarrantyFERRET BRAND LIMITED PRODUCT WARRANTYGxT, Inc. of Cheboygan Michigan, warrants to the original purchaser that FERRET brand products are free

Seite 14 - Coil Test

21SAFETY PRECAUTIONS—Read All Instructions Before Using The Meter—• Always wear eye protection when testing vehicles. Be extra careful near batteries

Seite 15

22Notes

Seite 17

24Copyright © 2006 GxT, Inc. Cheboygan Michigan, USAE095-01

Seite 18 - Parts & Accessories

3SpecificationsDC Volts ...3 Ranges ... 1 mV to 50VAC Volts (True RMS) ...3 Ranges ...

Seite 19

4Battery Replacement / Optional BatteryWhen the LOBAT indicator comes on the display, you will need to replace the two 9 Volt batteries. Remove the 4

Seite 20 - Warranty

5Function ButtonsPress this button to turn the multimeter on and off.Press this button to set configure the RPM to read in 2 Cycle or 4 Cycle mode. Di

Seite 21

6Key Combinations & Special FunctionsBacklight ControlPress the HOLD button and the Min/Max button at the same time to turn the backlight

Seite 22

7VoltsPressing the button will cycle you through DC Volts, AC volts, and AC Peak to Peak functions. The bargraph is an easy way to

Seite 23

8989LOBATMAXMINΩHOLDContinuity DisplayOhmsThe highest Ohms range allows up to 40M Ohms to be measured. All of the ranges except the lowest u

Seite 24

9AmpsWhen the test is first selected the message “PLUG In HI” will be briefly displayed to remind the user that the High range Amps p

Kommentare zu diesen Handbüchern

Keine Kommentare